Home > 50 GPD TFC Pure-Flo II RO Unit 2 Canister
50 GPD TFC Pure-Flo II RO Unit 2 Canister

Product Description
Energy Savers Unlimited
Insure the health of your fish by providing them with clean, healthy water! Pure-Flo II TFC R.O. systems will purify 24 or 50 gallons of water per day, removing up to 98% of disease-causing contaminants. A 1-micron sediment and carbon block pre-filter will ensure the purity of your water as it passes through the TFC membrane which removes even the tiniest of microscopic dissolved substances. Also available with a special Deionization canister (built-in or as a single unit sold separately) which will post-filter any minute amount of remaining impurities, providing the absolute purest water possible, 99% pure! Protect your aquarium investment from those invisible contaminants with a Pure-Flo II R.O. system. For use on chlorinated or non-chlorinated water sources.
Instructions:
**NOTE: DISCARD FIRST 10 GALLONS OF WATER PRODUCED**
Ideal water conditions:
Water pressure: 60 PSI
Water temperature: 69-78 degrees F.
Membrane installation:
Unscrew nut on elbow fitting and remove water line.
Unscrew membrane housing cap.
Insert membrane into membrane housing.
Replace membrane housing cap.
Canister removal:
Slide canister wrench over cartridge canister. Turn wrench to loosen canister.
Remove cartridge canister.
Flush carbon block cartridge with tap water for a minimum of 5 minutes before use.
Plumbing hook-up:
Attach inlet for source water to chlorinated or well water supply (yellow tube).
NOTE: to attach directly to your faucet, attach the faucet adaptor to the inlet for source water.
Route wastewater outlet line to drain (white tube). Z
Route purified water outlet line to storage container (blue tube).
Make sure all plumbing fittings and membrane housing cap are screwed down tight.
Plug in the pump.
Pure-Flo II - 50 gallon-per-day system includes:
50 GPD TFC membrane
1 micron filter cartridge
Carbon block filter cartridge
Ideal Source Water Conditions:
Chlorinated or non-chlorinated water supplies
Water pressure - 60 PSI
Water temperature range: 69 - 78 degrees Fahrenheit
Replacement Filters:
76010 - 1 micron cartridge replace every six months minimum
76012 - Carbon block replace every six months or 2,500 gallons
76021 - 50 gallon-per-day TFC replacement membrane replace every 2 to 3 years
NOTE: Change times are varied depending water conditions. Stated times are an average.
Membrane Specifications:
Length: 11 3/4"
Diameter: 1 1/2"
Body Length: 10"
Specifications:
Length: 14"
Width: 5 7/8"
Height: 15"
Dry weight: 7 1/2 lbs.
3 gallons waste water to 1 gallon production water
Maximum Total Dissolved Solids (TDS) in source water less than 250 ppm
Membrane type: TFC (Thin Film Composite)
Rated Gallons Per Day: 50
Inlet for source water: 3/4" garden hose connection with faucet adaptor and 3/8" pressure tubing
Tubing type: 1/4" pressure tubing
Warranty:
Unit has a 1 year warranty against defects in material and workmanship